Wiper Gear Box: Service and Repair
WIPER TRANSMISSION REPLACEMENTTOOLS REQUIRED
- J 39232 Wiper Linkage Separator
- J 39529 Wiper Linkage Installer
REMOVAL PROCEDURE
1. Remove the wiper arms (1,4).
2. Remove the air inlet grille panel.
3. Pull or push on the wiper transmission linkage to rotate the wiper motor crank arm (2) from the park position (1) to the area opposite the park position (3).
4. Disconnect the wiper motor harness connector (4).
5. Remove the 2 screws (3,5) retaining the wiper system drive module.
6. Remove the wiper system drive module (1) from the vehicle.
7. Remove the drive links from the wiper motor crank arm and the wiper transmission drive shafts with the J 39232.
8. Remove the transmission links from the module.
INSTALLATION PROCEDURE
1. Position the transmission drive links (4) to the pivot arms (3,5).
2. Install the drive links onto the wiper motor crank arm and the wiper transmission drive shafts with the J 39529.
3. Install the wiper motor module assembly.
4. Install the air inlet grille panel.
5. Install the wiper arms (1,4).
6. Operate the wipers and check for proper operation.