Antenna, Radio: Service and Repair
ANTENNA REPLACEMENT - DIGITAL RADIOREMOVAL PROCEDURE
NOTE: Do NOT apply paint or clear coat to the XM band radio antenna. This will damage the function of the antenna, causing poor reception or loss of reception of the XM digital signal.
1. Remove the rear sail panels.
NOTE: Use care when removing or installing the headliner. Excessive bending will damage the headliner.
2. Lower the rear of the headliner.
3. Remove the foam tape from the antenna cable connection.
4. Disconnect the digital radio antenna connectors (1).
5. Remove the antenna bolt (2) and expansion sleeve (3).
IMPORTANT: The retainer, located on the shaft of the radio antenna, was designed for assembly plant operations to retain the digital antenna to the roof before the bolt is installed. If the retainer on the radio antenna is broken or damaged during service of the antenna, the antenna will still operate as designed and should be reused.
6. Squeeze the retainer (4), located on the shaft of the antenna near the base, with a pair of pliers.
7. Remove the digital radio antenna.
INSTALLATION PROCEDURE
1. Install the digital radio antenna to the roof.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.
Tighten
Tighten the bolt to 6 N.m (53 lb in).
3. Connect the antenna connectors (1).
4. Wrap the connectors (1) with foam tape.
5. Install the antenna cable connection above the AM/FM antenna module.
6. Install the antenna cable hold down clips.
7. Align the headliner to the roof panel.
8. Install the rear sail panels.