Upper Intake Manifold Cover Replacement - Rear
Upper Intake Manifold Cover Replacement - RearRemoval Procedure
1. Remove the cross car brace, if necessary.
2. Remove the oil fill cap.
3. Disengage the cover/shield from the ball studs by pulling up firmly on the rear and front of the engine cover.
4. Remove the engine cover/sight shield.
5. Remove the nut from the rear stud.
6. Remove the cover from the upper studs.
Installation Procedure
1. Install the cover to the upper studs.
2. Install the cover to the rear stud.
3. Notice: Install the cover nut.
Tighten the cover nut to 23 Nm (17 ft. lbs.).
4. Position the engine cover/sight shield over the intake manifold so the grommets are aligned with the ball studs.
5. Press the engine cover/sight shield down firmly near the ball studs in order to install the engine cover/sight shield.
6. Install the oil fill cap.
7. Install the cross car brace, if necessary.