132. Camshaft Cover Installation - Right
Camshaft Cover Installation - RightTools Required
^ EN 46101 Spark Plug Tube Seal Guide
^ EN 46105 Camshaft Locking Tool
1. Remove the EN 46105-1 from the rear of the right camshafts.
2. Install the EN 46101 onto the spark plug tubes of the right cylinder head.
3. Install the camshaft cover bolt grommets prior to installing the camshaft cover bolts.
4. Wipe the camshaft cover sealing surface on the right cylinder head with a clean, lint-free cloth.
5. Place a bead 8 mm (0.3150 inch) in diameter by 4 mm (0.1575 inch) in height of RTV sealant, GM P/N 12378521 (Canadian P/N 88901148) or equivalent, on the engine front cover split lines (1).
6. Place the right camshaft cover into position onto the right cylinder head.
7. Loosely install the right camshaft cover bolts.
8. Notice: Tighten the right camshaft cover bolts in the sequence shown.
Tighten the right camshaft cover bolts in the sequence to 10 Nm (89 inch lbs.).
9. Remove the EN 46101 from the spark plug tubes of the right cylinder head.
10. Install the NEW spark plugs into the right cylinder head.
Tighten the spark plugs to 20 Nm (15 ft. lbs.).
11. Install each ignition coil through the right camshaft cover into the spark plug tube taking care not to damage the spark plug and/or the seal in the right camshaft cover.
12. Install each ignition coil bolt.
Tighten the ignition coil bolt to 10 Nm (89 inch lbs.).