Lubricant Level Inspection - Rear Drive Axle

Lubricant Level Inspection - Rear Drive Axle

Inspection Procedure





1. Raise and support the vehicle.
2. Clean any dirt from around the differential fill plug.
3. Remove the fill plug from the differential and drain the fluid.
4. Check the differential fluid level. it should be even with the bottom of the fill plug hole to no lower than 6 mm (0.25 inch) below the opening.
5. Add new fluid if necessary.
6. Fill the differential with 75W90 synthetic axle lubricant, GM P/N 12378261 (Canadian P/N 10953455) or equivalent.

7. Install the differential fill plug to the differential.
Tighten the differential fill plug to 39 Nm (29 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

8. Lower the vehicle.