Throttle Body Assembly Replacement

THROTTLE BODY ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the air cleaner intake duct.

NOTE: DO NOT use any mechanical device such as pliers or screwdrivers to disengage the connector. In order to prevent damage to the connector or harness wiring, both of the latches on the connector must be depressed with finger pressure only. When the latches are depressed the connector must then be pulled straight back without pulling on the wires in order to disengage. Failure to follow this procedure can lead to connector or wiring harness damage and failure.




3. Remove the throttle body electrical connector.




4. Unlock and reposition the wiring harness conduit.




5. Remove the throttle body bolts.
6. Remove the throttle body and gasket.

INSTALLATION PROCEDURE
1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.




2. Install the throttle body and NEW gasket.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the throttle body bolts.

Tighten
Tighten the throttle body bolts to 10 N.m (89 lb in).




4. Install the wiring harness conduit.




5. Install the throttle body electrical connector.
6. Install the air cleaner intake duct.
7. Perform the idle learn procedure. Refer to Idle Learn Procedure.
8. Use the scan tool to clear all DTCs.