Wiper Motor Module Grommet Replacement (LHD)

WIPER MOTOR MODULE GROMMET REPLACEMENT (LHD)

REMOVAL PROCEDURE




1. Remove the wiper motor fuse. The wiper motor fuse is located in the underhood fuse block.
2. Remove the wiper arm assemblies.
3. Remove the air inlet grille (1,3).




4. Remove the wiper motor module mounting bolts (3,5).
5. Disconnect the wiper motor electrical connector (4).
6. Remove the wiper motor module (1) from the vehicle.
7. Remove the following wiper motor module grommets:
- round (2)
- oval (6)
- pin (7)

INSTALLATION PROCEDURE
1. Install the following wiper motor module grommets:
- round (2)
- oval (6)
- pin (7)




2. Place the wiper motor module into the vehicle.
3. Connect the wiper motor module electrical connector (4).
4. Align the wiper module locator hole (7) to the pin located inside rail of the driver side fender.
5. Align the locator hole (6) to the hole in the pillar flange.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the outer fastener (5).

Tighten
Tighten the outer fastener to 10 N.m (89 lb in).

7. Install the center fastener (3).

Tighten
Tighten the center fastener to 10 N.m (89 lb in).




8. Install the air inlet grille (1,3).
9. Install the wiper arm assemblies.
10. Install the wiper motor fuse in the underhood fuse block.