Engine Balancing

Engine Balancing
During the powertrain build process, balance weights may be added to the crankshaft balancer and/or flywheel as required.

In order to maintain engine/clutch assembly balance, it may be necessary to install or remove balance weights as detailed below:

Crankshaft Balancer
^ Existing balancer onto existing engine: The balancer position must be marked prior to removal and installed to the original position.
^ New balancer onto an existing engine: Install the same size balance weights into the new balancer in the same location as the old component.

Engine Flywheel

Important: The pressure plate mounts or locates onto the flywheel via two dowel pins in the flywheel. If the pressure plate is not aligned properly onto the dowel pins and tightened down, the pins may bend and the plate may be incorrectly positioned which will effect component balance.

^ Existing flywheel, clutch, and pressure plate onto the existing engine: Flywheel position must be marked prior to removal and installed to the original position.
^ Existing flywheel, clutch, and pressure plate onto a new engine: Remove balance weights, if applicable from the flywheel.
^ New flywheel, clutch, and/or pressure plate onto an existing engine: Do not transfer or install balance weights.
^ New flywheel, clutch, and/or pressure plate onto a new engine: Do not install balance weights.