Zone 12

1. Remove the key from the ignition switch.




2. Connect the RR side impact module yellow connector (3) to the vehicle harness yellow connector (2).
3. Install the CPA to the RR side impact module yellow connector (3).
4. Install the rear seat back.




5. Install the SIR fuse into the rear fuse center.
6. Install the rear fuse center cover.
7. Install the rear seat.
8. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
9. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Restraint Systems.