Module Replacement - Ventilation Heat and Cool - Seat Back
MODULE REPLACEMENT - VENTILATION HEAT AND COOL - SEAT BACKREMOVAL PROCEDURE
1. Remove the seat back trim.
2. Remove the seat cushion in order to access the electrical connector.
3. Disconnect the electrical connector that attaches the harness to the module (4).
CAUTION: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
4. Drill out the rivets (3) retaining the module to the seat back frame.
5. Remove the module from the seat back frame.
INSTALLATION PROCEDURE
1. Install the module (4) to the seat back frame.
2. Install the rivets (3) retaining the module to the seat back frame.
3. Connect the electrical connector that attaches the harness to the module.
4. Install the seat cushion.
5. Install the seat back trim.