Disc Brake Backing Plate Replacement Rear (J55)
Disc Brake Backing Plate Replacement Rear (J55)Caution: Refer to Brake Dust Caution.
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Remove the brake caliper and mounting bracket as an assembly.
5. Pull down on the front park brake cable and remove the intermediate cable from the connector.
6. Remove the park brake cable from the brake caliper lever.
7. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
8. Remove the brake rotor.
9. Remove the hub and bearing assembly.
10. Remove the park brake shoe.
11. Remove the backing plate bolts.
12. Remove the backing plate.
Installation Procedure
Important: The backing plate bolts threads and the threaded holes of the knuckle must be free of residue and debris prior to reapplication of threadlocker in order to ensure proper adhesion and fastener retention.
1. Install the backing plate.
Prepare the bolts and the threaded holes for assembly:
^ Thoroughly clean the residue from the bolt threads by using denatured alcohol or equivalent and allow to dry.
^ Thoroughly clean the residue from the threaded holes by using denatured alcohol or equivalent and allow to dry.
^ Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) or equivalent to two-thirds of the threaded length of the lower caliper bracket bolts. Ensure that there are no gaps in the threadlocker along the length of the filled area of the bolts.
^ Allow the threadlocker to cure approximately ten minutes before installation.
Notice: Refer to Fastener Notice.
2. Install the backing plate bolts.
^ Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
3. Install the park brake shoe.
4. Adjust the park brake shoe.
5. Install the hub and bearing assembly.
6. Install the brake rotor.
7. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
8. Install the park brake cable to the brake caliper lever.
9. Pull down on the front park brake cable and connect the intermediate cable from the connector.
10. Install the caliper and mounting bracket as an assembly.
11. Install the tire and wheel assembly.
12. Lower the vehicle.