117. Starter Installation

1. If installing a NEW starter transfer the cables from the old starter.
2. Install the positive battery cable to the starter motor stud.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the starter motor stud nut.
^ Tighten the starter motor stud nut to 9.5 Nm (84 in. lbs.).
4. Install the solenoid wiring harness to the starter solenoid stud.
5. Install the starter solenoid stud nut.
^ Tighten the starter solenoid stud nut to 3.4 Nm (30 in. lbs.).
6. Place the starter motor in position in the engine valley.
7. Install the two starter motor retaining bolts.
^ Tighten the starter motor retaining bolts to 30 Nm (22 ft. lbs.).





8. Install the knock sensor.
^ Tighten the knock sensor to 20 Nm (15 ft. lbs.).





9. Connect the knock sensor wire leads.