Wheel Speed Sensor Replacement - Rear (W/FE7)

Wheel Speed Sensor Replacement - Rear (w/FE7)

^ Tools Required
- J 39200 Digital Multimeter
- J 44252 ABS Sensor Installer

Caution: Refer to Brake Dust Caution.

Removal Procedure





1. Turn OFF the ignition.
2. Raise the vehicle.
3. Remove the rear wheel.
4. Remove the wheel speed sensor connector (1) from the wheel speed sensor (2).

Important: Do not reuse the wheel speed sensor after it has been removed.

5. Remove and discard the wheel speed sensor (2).

Installation Procedure





Important: The connector of the wheel speed sensor must point toward the brake caliper.

1. Insert the wheel speed sensor (1) onto the hub assembly.
2. Install the ring (2) of the J 44252 onto the wheel speed sensor.





3. Insert the J 44252 (1) onto the wheel speed sensor (3).
4. Pull the J 44252 (1) to seat the wheel speed sensor (3).





5. Test the output of the wheel speed sensor.
5.1. Connect the J 39200 to the wheel speed sensor connector.
5.2. Set the J 39200 to AC voltage.

Important: For a proper wheel speed sensor signal, the AC voltage will measure greater than 100 mV while the wheel is spinning.

5.3. By hand, spin the wheels
6. Install the wheel speed sensor connector (1) to the wheel speed sensor.
7. Install the rear wheel.
8. Lower the vehicle.