Lumbar Switch Replacement - Rear (Dhs)

LUMBAR SWITCH REPLACEMENT - REAR (DHS)

REMOVAL PROCEDURE




1. Remove the rear door trim panel.
2. Place the door panel inside up, on a clean protected surface.
3. Remove the fasteners (1) securing the rear lumbar switch (2) to the rear door panel.




4. Remove the rear lumbar switch (2) from the rear door panel.
5. Disconnect the electrical connector (1) from the rear lumbar switch (2).

INSTALLATION PROCEDURE




1. Connect the electrical connector (1) to the rear lumbar switch (2).
2. Install the rear lumbar switch (2) to the rear door panel.




3. Install the fasteners (1) to the rear lumbar switch (2).
4. Install the rear door trim panel.