Engine Controls - No Start/Multiple DTC's Set
File In Section: 06 - Engine/Propulsion SystemBulletin No.: 04-06-04-060
Date: September, 2004
TECHNICAL
Subject:
Engine Cranks But Does Not Start, No Injector Pulses, DTC Codes P0118, P0122, P0335, P0385, P0412, and/or P0340 Set (Reprogram PCM)
Models:
2004 Cadillac Seville
2004-2005 Cadillac DeVille DTS, DHS
2004-2005 Pontiac Bonneville GXP
with 4.6L Northstar Engine (VINs Y, 9 - RPOs LD8, L37)
Built Prior to the VIN Breakpoints shown.
Condition
Some owners may comment on a crank, no start condition. In addition, the vehicle may have some or all of the following PCM codes stored: P0118, P0122, P0335, P0385, P0412, and P0340. There may also be other PCM codes present. If the battery power is removed from the ECM, then reconnected, the vehicle will start and run.
Cause
Diagnosis may lead to no injector pulses as the cause of the no start condition.
This condition is sometimes described as PCM logic lock up.
Correction
Reprogram the PCM with the latest calibration listed below or later.
The new calibration will be released beginning with TIS satellite data update version 8.0 for 2004, which includes TECH2� update version 24.005, available August 2004. As always, make sure your TECH2� is updated with the latest software version.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer