Multifunction, Turn Signal Switch

Multifunction, Turn Signal Switch Replacement

Removal Procedure

Caution: Refer to SIR Caution. Vehicle Damage Warnings





1. Disable the SIR system.
2. Remove the steering column trim covers.
3. Remove the retaining screws from the multifunction switch.
4. Disconnect the multifunction switch electrical connections.
5. Remove the multifunction switch.

Installation Procedure





1. Connect the multifunction switch electrical connectors.
2. Install the multifunction switch to the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the retaining screws to the multifunction switch.
^ Tighten the screws to 7 Nm (62 in. lbs.).
4. Install the steering column trim covers.
5. Enable the SIR system.