Window Replacement - Rear Door (RPO WC2 and WC8 w/ Stationary Window)

Window Replacement - Rear Door (RPO WC2 and WC8 w/ Stationary Window)

Removal Procedure

1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door (Standard) (Trim Panel Replacement - Side Rear Door (Standard))Trim Panel Replacement - Side Rear Door (WC2, WC8) (Trim Panel Replacement - Side Rear Door (WC2, WC8)) .
2. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
3. Remove the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner (Service and Repair) .
4. Tape the window in place.
5. Remove the front window channel. Refer to Window Channel Replacement - Rear Door Front (Window Channel Replacement - Rear Door Front) .
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.




6. Remove the 4 10-mm attaching nuts from the lower glass attachment brackets (3).
7. Remove the lower glass attachment brackets (3).




8. Remove the rear window channel lower fasteners.
9. Remove the window from the door in the following order:

1. While supporting the window through the access hole of the inner panel, remove the tape holding the window up.
2. Lower the window slightly.
3. Position the window forward, away from the rear window channel.
4. Carefully position the window rearward between the inner door panel and the division post.
5. Tilt the window outward, while pulling the window up and out of the door from the outer side of the window opening.




Installation Procedure





1. Install the window into the door in the following order:

1. Carefully lower the window into the door from the outer side window opening, making sure the rear edge of the window is between the inner door panel and the division post.
2. Position the window forward, away from the rear window channel.
3. Raise the window to the full up position.
4. Tape the window in place.


Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the rear window channel lower retaining fastener (1).

Tighten the fastener to 9 N.m (80 lb in).





3. Install the lower window attachment brackets (3).
4. Install the 4 10-mm attaching nuts.

Tighten the fasteners to 18 N.m (24 lb ft).

5. Install the front window channel. Refer to Window Channel Replacement - Rear Door Front (Window Channel Replacement - Rear Door Front) .
6. Remove the tape from the window.
7. Install the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner (Service and Repair) .
8. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
9. Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door (Standard) (Trim Panel Replacement - Side Rear Door (Standard))Trim Panel Replacement - Side Rear Door (WC2, WC8) (Trim Panel Replacement - Side Rear Door (WC2, WC8)) .