Mirror Replacement - Power Mirror

Mirror Replacement - Power

Removal Procedure

1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair).
2. Remove the door frame garnish molding. Refer to Garnish Molding Replacement - Front Door Frame (Garnish Molding Replacement - Front Door Frame).




3. Disconnect the electrical connectors (2).
4. Remove the three fasteners (3).
5. Disconnect the wire harness from the retainer clip and unseat the grommet.
6. Route the wiring harness through the hole in the mirror patch.
7. Remove the mirror (1) from the door.



Installation Procedure





1. Route the mirror wiring harness through the hole in the mirror patch.
2. Install the mirror (1) into the door frame.
3. Align the studs through the holes in the mirror patch.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the three fasteners in order to secure the mirror to the door.

Tighten the mirror fasteners to 9 N.m (80 lb in).


* Top nut
* Forward nut
* Rear nut

5. Install the grommet by gently pulling into place.
6. Connect the electrical connectors.
7. Install harness into retainer clip.
8. Install the door frame garnish molding. Refer to Garnish Molding Replacement - Front Door Frame (Garnish Molding Replacement - Front Door Frame).
9. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair).