128. Engine Flywheel Installation

Engine Flywheel Installation

^ Tools Required
- J 45059 Torque Angle Meter
- J 44214 Flywheel Holder





1. Apply sealant, GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the engine flywheel retaining bolts.
2. Place the engine flywheel in position on the crankshaft.
3. Slip one bolt into the engine flywheel washer.
4. Install the washer and bolt in a location at the top of its rotation allowing the engine flywheel to hang in position.

Notice: Refer to Fastener Notice in Service Precautions.





5. Install the remaining engine flywheel bolts.
5.1. Install the J 44214 to the engine block.
5.2. First Pass
Tighten the engine flywheel retaining bolts to l5 Nm (11 ft. lbs.).
5.3. Final Pass
Tighten the engine flywheel retaining bolts an additional 50 degrees using the J 45059.