Valve Seat Width Measurement Procedure

Valve Seat Width Measurement Procedure





1. Measure the valve seat width in the cylinder head using a proper scale.





2. Measure the seat width on the valve face (1) using a proper scale.

Important: The seat contact area must be at least 0.5 mm (0.020 inch) from the outer diameter, margin, of the valve. If the contact area is too close to the margins, the seat must be reconditioned to move the contact area away from the margin.

3. Compare your measurements with the specifications listed in Specifications.
4. If the seat widths are acceptable, check the valve seat roundness using the Valve Seat Roundness Measurement Procedure.
5. If the seat width is not acceptable, you must grind the valve seat using the Valve and Seat Reconditioning Procedure to bring the width back into specification. Proper valve seat width is critical to providing the correct amount of valve heat dissipation.