Air Temperature Door Replacement - Left
AIR TEMPERATURE DOOR REPLACEMENT - LEFTREMOVAL PROCEDURE
1. Remove the HVAC Module.
2. Remove the mode actuator.
3. Remove the recirculation actuator screw.
4. Remove the right temperature actuator screw.
5. Remove the left temperature actuator screw.
6. Remove the fasteners that retain the mode actuator bracket.
7. Remove the mode actuator bracket.
8. Remove the upper module case fasteners.
9. Peel back the foam at the heater inlet.
10. Remove the upper case.
11. Remove the left temperature door.
INSTALLATION PROCEDURE
1. Install the left temperature door.
2. Install the upper module case.
3. Install the module case screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
4. Reapply the foam at the heater inlet.
5. Install the mode actuator and bracket.
6. Install the left temperature actuator screw.
Tighten
Tighten the screw to 1.4 N.m (12 lb in).
7. Install the right temperature actuator screw.
Tighten
Tighten the screw to 1.4 N.m (12 lb in).
8. Install the recirculation actuator screw.
Tighten
Tighten the screw to 1.4 N.m (12 lb in).
9. Install the HVAC module.