Suction Hose Replacement
SUCTION HOSE REPLACEMENTTOOLS REQUIRED
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Recover the refrigerant from the system.
2. Remove the suction hose retaining nut from the accumulator.
3. Remove the suction hose from the accumulator.
4. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Remove the front air deflector.
6. Disconnect the suction hose from the compressor.
7. Remove the suction hose.
INSTALLATION PROCEDURE
IMPORTANT: Inspect the sealing washers for damage. Replace the sealing washers that show any signs of damage. Sealing washer do not require lubricant.
1. Install the suction hose.
2. Connect the suction hose to the compressor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the suction hose to 20 N.m (15 lb ft).
3. Lower the vehicle.
4. Install the suction hose to the accumulator.
5. Install the suction hose retaining nut.
Tighten
Tighten the suction hose to 20 N.m (15 lb ft).
6. Recharge the A/C system.
7. Leak test the fittings of the repaired or reinstalled component using J 39400-A.
8. Install the front air deflector.