Power Door Lock Switch Replacement

POWER DOOR LOCK SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the inside door handle.




3. Remove the two screws from the switch.
4. Remove the door lock switch from the inside of the door panel.

INSTALLATION PROCEDURE




1. Align the door lock switch.
2. Install the two screws.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the two screws to 2 Nm (18 lb in).

3. Install the inside door handle.
4. Install the door trim panel.