Power Seat Motor Position Sensor: Service and Repair

POWER RECLINER SENSOR REPLACEMENT - FRONT

REMOVAL PROCEDURE
1. Disable the SIR system.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the front bucket seat.
3. Remove the seat back trim cover.




4. Remove retainer clip from the recliner motor end of the recliner shaft.




5. Slide the recliner shaft out of recliner motor sensor (outboard side) far enough to clear sensor.
6. Disconnect sensor electrical connector from beneath the seat.
7. Release the recliner sensor from the recliner motor.

INSTALLATION PROCEDURE
1. Install the recliner sensor to the recliner motor.
The recliner sensor snaps onto the recliner motor.




2. Slide recliner shaft back through the recliner sensor and recliner motor.




3. Install the retaining clip to the recliner shaft.
4. Connect the recliner motor electrical connector.
5. Install the seat back trim cover.
6. Install the front bucket seat.
7. Enable the SIR system.