Operation CHARM: Car repair manuals for everyone.

Wheel Speed Sensor Jumper Harness Replacement - Front Right

Wheel Speed Sensor Jumper Harness Replacement - Front (Right)

Removal Procedure

Important: The wheel speed sensor wiring is inch deaf in the engine harness. The wiring between the wheel speed sensor and the heat shrink sealed splices is high-flex cable and must not be repaired or spliced. This procedure replaces the high-flex cable with a jumper harness from a supplied repair kit.





1. Turn OFF the ignition.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the right front wheel.
4. Disconnect the wheel speed sensor connector (7) from the wheel speed sensor (6).
5. Disconnect the harness grommet (3) from the strut bracket (5).
6. Disconnect the harness grommet (1) from the rail bracket (2).
7. Disconnect the harness clip (4) from the rail bracket (2).





8. Cut the engine harness conduit (1) to locate the 2 heat shrink sealed splices.

Installation Procedure





1. Replace the wheel speed sensor jumper harness.
2. Route the wheel speed sensor jumper (4) through the engine compartment to the wheel well.





3. Using the strap (1), secure the wheel speed sensor jumper (2) to the HVAC lines (3).





4. Raise the vehicle. Refer to Vehicle Lifting.
5. Connect the wheel speed sensor connector (7 to the wheel speed sensor (6).
6. Connect the harness grommet (3) to the strut bracket (5).
7. Connect the harness grommet (1) to the rail bracket (2).
8. Connect the harness clip (4) to the rail bracket (2).
9. Install the right front wheel.
10. Lower the vehicle. Refer to Vehicle Lifting.
11. Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - ABS.