Power Window Switch: Service and Repair

POWER WINDOW SWITCH REPLACEMENT - REAR DOOR

REMOVAL PROCEDURE




1. Insert a flat bladed tool under the rear edge of the rear window switch plate.
2. Push the tool firmly towards the switch plate in order to disengage the retainer.

NOTE: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.

3. Lift up on the rear of the switch plate in order to remove it from the door trim panel.




4. Disconnect the electrical connectors.
5. Remove the switch plate assembly.
6. Remove the switch from the switch plate by disengaging the side snap walls with small flat bladed tool.

INSTALLATION PROCEDURE
1. Snap the switch into the switch plate.




2. Connect the electrical connectors.
3. Install the switch plate into the door trim panel.
4. Engage the front of the switch plate to the door panel.
5. Press down on the switch plate evenly in order to engage the retainer clips.