Telescope Actuator Switch

Telescope Actuator Switch Replacement

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the steering column.





3. Remove the retaining screws (2) from the lower steering column trim cover.
4. Remove the trim cover (1) from the closeout shroud.





5. Remove the tie straps (2) from the wiring harness.





6. Disconnect the electrical connectors (2) from the module.

Important: Note the direction that the wiring harness is routed for re-installation.





7. Open the lower wiring harness shield (1) and remove the wiring harness.





8. Remove the tilt and telescope switch (2) from the lower steering column trim cover (1).

Installation Procedure





1. Install the tilt and telescope switch (2) to the lower steering column trim cover (1).





2. Install the wiring harness (2) to the lower wiring harness shield (1).





3. Connect the electrical connectors (2) to the module.





4. Install the tie straps (2) to the wiring harness.





5. Install the lower steering column trim cover (1) to the steering column closeout shroud and to the upper steering column trim cover.
Ensure that the tabs (2) on the trim covers engage. Snap the trim covers together.
6. Install the retaining screws to the lower trim cover (2).
Tighten the screws to 3.5 Nm (31 inch lbs.).
7. Install the steering column.
8. Enable the SIR system.