Wiper Motor Cover Replacement (RHD)

WIPER MOTOR COVER REPLACEMENT (RHD)

REMOVAL PROCEDURE




1. Disconnect the electrical harness connector from the wiper motor cover.
2. Remove the screws.
3. Remove the wiper motor cover from the wiper motor.
4. Remove the wiper motor cover from the vehicle.

INSTALLATION PROCEDURE




1. Position the wiper motor cover to the wiper motor.
2. Install the wiper motor screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2.0 N.m (18 lb in).

3. Connect the harness electrical connector to the wiper motor cover.
4. Inspect the wiper washer system for proper operation.