Radio Replacement (With RPO Code U1R, UL6, UM5, UM9)

RADIO REPLACEMENT (WITH RPO CODE U1R, UL6, UM5, UM9)

REMOVAL PROCEDURE




1. Remove the instrument panel center trim plate.
2. Remove the console trim plate.
3. Remove the HVAC control and the radio bracket screws.




4. Disconnect the antenna and electrical connectors from the radio and the HVAC control assembly.




5. Remove the radio retaining nuts.
6. Remove the radio from the radio bracket.

IMPORTANT: New and remanufactured radios do not come with mounting brackets, studs or nuts. The hardware will need to be transferred to the replacement radio.

7. If the radio is to be replaced, remove the hardware from the radio.

INSTALLATION PROCEDURE




1. Install the mounting hardware to the radio.
2. Install the radio to the radio bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the radio retaining nuts.

Tighten
Tighten the radio retaining nuts to 5 N.m (44 lb in).




4. Connect the antenna and electrical connectors to the radio and the HVAC control assembly.




5. Install the HVAC control and the radio assembly.

Tighten
Tighten the screws to 2 N.m (18 lb in).

6. Install the console trim plate.
7. Install the IP center trim plate.