Sunroof / Moonroof: Service and Repair
SUNROOF MODULE ASSEMBLY REPLACEMENTTOOLS REQUIRED
J 44363 Sunroof Alignment Pins
REMOVAL PROCEDURE
1. Remove the sunroof window.
2. Remove the sunshade panel.
3. Remove the headliner.
4. Disconnect the electrical harness.
5. Cut the tie wraps from the drain hoses.
6. Disconnect the drain hoses from the sunroof module assembly.
7. Remove the sunroof module assembly to the roof bolts (1).
8. Remove the sunroof module assembly from the vehicle.
INSTALLATION PROCEDURE
1. Position the sunroof module assembly to the roof opening.
2. Hand start the sunroof module assembly bolts (1) into the roof.
3. Insert the J 44363 into the sunroof module assembly alignment holes (2).
4. Secure the sunroof module assembly to the roof.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the sunroof module assembly bolts (1) to 9 N.m (80 lb in).
5. Remove the J 44363.
6. Connect the drain hoses to the drain spouts on the sunroof module assembly.
7. Secure the drain hoses to the sunroof module with new tie wraps.
IMPORTANT: When installing the new drain hose tie wraps, position the tie wraps to maintain clearance between the tie wraps and the headliner.
8. Connect the electrical harness to the sunroof module assembly.
9. Install the sunshade.
10. Install the sunroof window and loosely install the screws.
11. Adjust the sunroof window.
12. Install the headliner.
IMPORTANT: Test for proper operation of the sunroof before installing the headliner.