114. Camshaft Cover Installation - Right

Camshaft Cover Installation - Right

^ Tools Required
- J 44212 Camshaft Holding Tool





1. Remove the J 44212 from the right cylinder head camshafts.





2. Ensure new camshaft cover seals are installed.
3. Place the right camshaft cover in position on the cylinder head by aligning the bolt holes.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the camshaft cover bolts.
^ Tighten the camshaft cover bolts to 10 Nm (89 inch lbs.).





5. Install the right ignition coil ground strap to the right cylinder head and right camshaft cover.
6. Install the right cylinder head ignition coil ground strap bolt.
^ Tighten the right cylinder head ignition coil ground strap bolt to 25 Nm (18 ft. lbs.).
7. Install the right camshaft cover ignition coil ground strap bolt.
^ Tighten the right camshaft cover ignition coil ground strap bolt to 10 Nm (89 inch lbs.).