Closeout/Insulator Panel Replacement - Right (RHD)

CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT (RHD)

REMOVAL PROCEDURE




1. Remove the fasteners (1) at the rear edge of the insulator.
2. Push on the left and the right retainers at the rear edge of the insulators in order to disengage the insulators from the lower IP.




3. Disconnect the electrical connectors (1,3).




4. Slide the insulator (2) rearward toward the vehicle in order to clear the park brake bracket.

INSTALLATION PROCEDURE




1. Slide the insulator (2) over the top of the park brake bracket.




2. Connect the electrical connectors (1,3).




3. Set the forward edge of the insulator onto the shelf on the carpeting at the front of the vehicle.
4. Align the insulator with the floor duct at the HVAC module.
5. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.
6. Install the insulator fasteners (1) into the lower IP.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the fasteners to 2 N.m (18 lb in).