Wiper Motor Cover Replacement (LHD)

WIPER MOTOR COVER REPLACEMENT (LHD)

REMOVAL PROCEDURE




1. Disconnect the harness connector from the wiper motor cover.
2. Remove the 3 screws.
3. Remove the wiper motor cover from the wiper motor.

INSTALLATION PROCEDURE




1. Install the wiper motor cover to the wiper motor with three screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2.0 N.m (18 lb in).

2. Connect the harness electrical connector to the wiper motor cover.
3. Inspect the wiper washer system for proper operation.