C0136

DTC C0136

Circuit Description
The Electronic Brake Control Module (EBCM) uses the input from the brake fluid pressure sensor for more accurate braking control during Vehicle Stability Enhancement System (VSES).

Conditions for Running the DTC
The ignition is ON for 1.0 second.

Conditions for Setting the DTC
One of the following conditions exists for 0.1 seconds.
^ The brake fluid pressure sensor signal is greater than 4.9 volts.
^ The brake fluid pressure sensor signal is less than 0.15 volts.

Action Taken When the DTC Sets
^ The EBCM disables the VSES for the duration of the ignition cycle.
^ ACC braking function disabled.
^ TCS is degraded.
^ The Traction Control and Active Handling indicator turns ON.
^ The DIC displays the Service Active Handling message.

Conditions for Clearing the DTC
^ The condition for the IDTC is no longer present and the DTC is cleared with a scan tool.
^ The electronic brake control module (EBCM) automatically clears the history DTC when a current IDTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids
^ Find out from the driver under what conditions the IDTC was set (when the DIC displayed the Service Stabilitrak message). This information will help to duplicate the failure.
^ The Snapshot function on the scan tool can help find an intermittent DTC.
^ A deceleration cycle consists of the following sequence:
1. The vehicle speed is greater than 24 km/h (15 mph).
2. The vehicle decelerates more than 8 km/h/second (5 mph/second) for 2 seconds.
3. The vehicle speed decelerates to less than 16 km/h (10 mph).

Test Description
The numbers below refer to the step numbers on the diagnostic table.
3. Tests for the proper operation of the circuit in the low voltage range.
4. Tests for the proper operation of the circuit in the high voltage range. If the fuse in the jumper opens when you perform this test, the signal circuit is shorted to ground.
5. Tests for a short to voltage in the 5-volt reference circuit.
6. Tests for a high resistance or an open in the low reference circuit.

Steps 1 - 3:

Steps 4 - 11:

Steps 12 - 16:

DTC C0136