P0068

DTC P0068

Circuit Description
The throttle position (TP) is compared to an expected throttle position based on engine load. The engine control module (ECM) determines engine load based on inputs from the mass air flow (MAF) and the manifold absolute pressure (MAP) sensors. If the ECM detects that the current load and throttle position are not consistent with the expected load and throttle position, DTC P0068 is set.

Conditions for Running the DTC
^ DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0121, P0122, P0123, P0221, P0222, P0223 are not set.
^ The engine speed is more than 600 RPM and less than 6,300 RPM.

Conditions for Setting the DTC
^ The ECM detects that the throttle position and indicated engine load do not correspond with the expected load and throttle position.

Action Taken When the DTC Sets
^ The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame and/or the Failure Records.
^ The control module commands the TAC system to operate in the Reduced Engine Power mode.
^ A message center or an indicator displays Reduced Engine Power.
^ Under certain conditions the control module commands the engine OFF.

Conditions for Clearing the MIL/DTC
^ The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Clear the MIL and the DTC with a scan tool.