Left Side Harness Connections Install
Engine Wiring Harness Assembly InstallationLeft Side Harness Connections
1. Connect the engine wiring harness to the left side fuel injectors.
2. Connect the engine wiring harness to the left camshaft cover.
3. Connect the engine wiring harness to the left ignition coil harness.
4. Connect the engine wiring harness to the left camshaft position sensors.
5. Connect the engine wiring harness to the EVAP purge solenoid.
6. Connect the engine wiring harness to the throttle position sensor on the throttle body.
Notice: Refer to Fastener Notice in Service Precautions.
7. Connect the starter motor wiring harness to the generator stud.
8. Install the nut attaching the starter motor wiring harness to the generator stud.
^ Tighten the generator stud nut to 20 Nm (15 ft. lbs.).
9. Connect the engine wiring harness to the generator.
10. Connect the engine wiring harness to the oil pressure sensor.
11. Connect the engine wiring harness from the oxygen sensor wiring harness.
12. Connect the engine wiring harness to the starter motor wiring harness.
13. Install the bolt and nut retaining the engine wiring harness to the engine block.
^ Tighten the engine wiring harness bolt and nut to 35 Nm (26 ft. lbs.).
14. Install the engine wiring harness ground bolt at the front of the engine block.
^ Tighten the engine wiring harness ground bolt to 35 Nm (26 ft. lbs.).
15. Install the engine wiring harness ground bolt at the rear of the engine block.
^ Tighten the engine wiring harness ground bolt to 12 Nm (106 inch lbs.).
16. Install the bolt retaining the engine wiring harness to the left camshaft position actuator housing.
^ Tighten the engine wiring harness bolt to 35 Nm (26 ft. lbs.).