83. Engine Front Cover Assemble

Engine Front Cover Assemble

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the generator cooling inlet hose fitting.
^ Tighten the generator cooling inlet hose fitting to 25 Nm (18 ft. lbs.).





2. Install the NEW thermostat gasket onto the thermostat.





3. Install the thermostat and gasket into the thermostat housing.





4. Install the thermostat housing.
5. Install the thermostat housing bolts.
^ Tighten the thermostat housing bolts to 10 Nm (89 inch lbs.).





6. Install the NEW water pump O-ring.





7. Install the water pump.
8. Install the water pump bolts.
^ Tighten the water pump bolts to 10 Nm (89 inch lbs.).