Parking Brake Warning Switch: Service and Repair
Park Brake Warning Lamp Switch ReplacementRemoval Procedure
1. Remove the LH closeout trim panel.
2. Remove the instrument panel cluster (IPC).
3. Remove the park brake assembly attaching nuts (1) and bolt (2).
4. Disconnect the park brake switch electrical connector.
5. Disconnect the park brake release solenoid electrical connector.
6. Position the park brake pedal assembly aside to gain access to the park brake warning lamp switch.
7. Remove the park brake warning lamp switch retainer.
8. Remove the park brake warning lamp switch from the park brake pedal assembly.
Installation Procedure
1. Install the park brake warning lamp switch to the park brake assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the park brake warning lamp switch retainer.
^ Tighten to 4 Nm (35 inch lbs.).
3. Position the park brake pedal assembly.
4. Install the park brake pedal assembly retaining nuts and bolt.
^ Tighten to 10 Nm (89 inch lbs.).
5. Connect the park brake release solenoid electrical connector.
6. Connect the park brake switch electrical connector.
7. Install the IPC.
8. Install the LH closeout trim panel.
9. Apply the park brake pedal and release 2-3 times, to assure proper function of the park brake system.