Folding Top Control Module Replacement

Folding Top Control Module Replacement

Removal Procedure




1. Place the folding top in the coupe position.
2. Open the rear compartment.
3. Disconnect the battery.




4. Lower the rear compartment partition (1).
5. Place a protective covering over the rear compartment interior and the adjacent body panels.
6. Remove the side compartment trim.




7. Remove 3 electrical connectors (1) from the hydraulic pump bracket (2).




8. Remove 2 electrical connectors (1) from the pump bracket (2).




9. Disconnect 3 electrical connectors (1) from the folding top control module.




10. Remove the bolts (1) from the hydraulic pump bracket.
11. Lift the pump up and out of the storage compartment and set the pump in the rear compartment on the protective covering.




12. Remove the screws (1) from the folding top control module (2).
13. Remove the control module.

Installation Procedure




1. Position the folding top control module (2) to the pump bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the screws (1) to the folding top control module.

Tighten the screws to 6 N.m (53 lb in).




3. Position the hydraulic pump to the mounting location.
4. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
5. Install the bolts (1) to the hydraulic pump bracket.

Tighten the bolts to 18 N.m (13 lb ft).




6. Connect the 3 electrical connectors (1) to the control module.




7. Install the 2 electrical connectors (1) to the pump bracket (2).




8. Install the 3 electrical connectors (1) to the pump bracket (2).
9. Install the side component trim.
10. Remove the protective covering.




11. Raise the rear compartment partition (1).
12. Connect the battery.
13. Close the rear compartment.
14. Calibrate the folding top. Refer to Power Folding Top Calibration Procedure.
15. Inspect the folding top for proper operation.