Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering, Shaft Upper Bearing Spring Replacement

^ Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Steering Column Lock Plate Compressor Adapter

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.

Important: Let the SIR coil hang freely after removal.

2. Remove the SIR coil from the steering column.
3. Remove the wave washer (1) from the steering shaft assembly (2).





4. Compress the cam orientation plate using J 23653-SIR and J 42137.
5. Remove the bearing retainer from the steering shaft assembly.
6. Remove J 23653-SIR and J 42137
7. Dispose of the bearing retainer.





8. Remove the following from the steering shaft:
8.1. Shaft lock shield (5)
8.2. Turn signal cancel cam assembly (4)
8.3. Upper bearing spring (3)
8.4. Upper bearing inner race seat (2)-,
8.5. Inner race (1)

Installation Procedure





1. Install the following to the steering shaft:
1.1. Inner race (1)
1.2. Upper bearing inner race seat (2)
1.3. Upper bearing spring (3)
1.4. Turn signal cancel cam assembly (4)
1.5. Shaft lock shield (5)





2. Install a new bearing retainer onto the steering shaft assembly.
3. Compress the cam orientation plate using J 23653-SIR and J 42137 to install the bearing retainer.
4. Remove J 23653-SIR and J 42137 from the steering shaft assembly.





5. Install the wave washer (1) onto the steering shaft assembly (2).
6. Install the SIR coil.
7. Enable the SIR system.