127. Engine Flywheel Installation

Engine Flywheel Installation

^ Tools Required
- J 45059 Angle Meter
- J 44214 Flywheel Holder

1. Apply sealant, GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the engine flywheel bolts.





2. Place the engine flywheel in position on the crankshaft.

3. Notice: Refer to Fastener Notice in Service Precautions.

Loosely install a bolt at the top and bottom of the bolt circle allowing the engine flywheel to hang in position.





4. Install the J 44214 to the engine block.
5. Install the remaining engine flywheel bolts.
6. Tighten the engine flywheel bolts.
1. First Pass
Tighten the engine flywheel retaining bolts to 15 Nm (11 ft. lbs.).
2. Final Pass
Tighten the engine flywheel retaining bolts an additional 50 degrees using the J 45059.