Driver Information Center Switch Replacement

DRIVER INFORMATION CENTER SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the IP cluster trim panel.

CAUTION: Refer to SIR Caution in Service Precautions.




2. Remove the fasteners from the drivers information switch.




3. Remove the drivers information switch from the IP cluster trim panel.

INSTALLATION PROCEDURE




1. Install the drivers information switch to the IP cluster trim panel.




2. Install the fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 2 N.m (18 lb in).

3. Install the IP cluster trim panel.