Turn Signal Switch: Service and Repair

Multifunction, Turn Signal Switch Replacement
Removal Procedure

1. Caution: Refer to Restraint Systems in Service and Precautions.

Disable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the steering column trim covers.





3. Remove the retaining screws from the multifunction switch.
4. Disconnect the multifunction switch electrical connections.
5. Remove the multifunction switch.

Installation Procedure
1. Connect the multifunction switch electrical connectors.
2. Install the multifunction switch to the steering column.





3. Notice: Install the retaining screws to the multifunction switch.

Tighten the screws to 7 Nm (62 inch lbs.).
4. Install the steering column trim covers.
5. Enable the SIR system. Refer to Restraint Systems Disabling and Enabling Zone 3 in Restraint Systems.