Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the camshaft sensor electrical connector.
2. Remove the camshaft retaining bolt.
3. Remove the camshaft sensor.

INSTALLATION PROCEDURE




1. Lubricate the camshaft o-ring with engine oil.

IMPORTANT: Inspect the camshaft sensor o-ring for wear or damage. If a problem is found, replace the o-ring.

2. Install the camshaft sensor and retaining bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the retaining bolt between 10 N.m (89 lb in).

3. Reconnect the camshaft sensor electrical connector.
4. Operate the engine and inspect the camshaft sensor for engine oil leaks.