Flex Plate: Service and Repair

Engine Flywheel Replacement

^ Tools Required
- J 45059 Angle Meter
- J 44214 Flywheel Holder

Removal Procedure





1. Remove the transaxle assembly.
2. Install the J 44214 to the engine block.





3. Loosen the 8 engine flywheel mounting bolts.
4. Remove 7 of the 8 flywheel bolts leaving 1 bolt at the top of the crankshaft rotation.
5. Grip the engine flywheel and remove the remaining bolt. Do not drop the engine flywheel when removing the final bolt.
6. Clean and inspect the engine flywheel.

Installation Procedure
1. Apply sealant, GM P/N 12346004 ( Canadian P/N 10953480) or equivalent, to the flywheel mounting bolts.





2. Place the engine flywheel in position on the crankshaft.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the mounting bolts.
1. First Pass
Tighten the flywheel mounting bolts to 15 Nm (11 lb ft).
2. Final Pass Tighten the flywheel mounting bolts an additional 50 degrees using the J 45059.
4. Remove the J 44214 from the engine block.
5. Install the transaxle assembly.