Power Recliner Motor Replacement - Front Seat

POWER RECLINER MOTOR REPLACEMENT - FRONT SEAT

REMOVAL PROCEDURE
1. Remove the front bucket seat.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the power recliner position sensor.
3. Disconnect the electrical connector from the motor.




4. Remove the recliner motor retaining nuts (1).
5. Slide the motor off of the shaft.

INSTALLATION PROCEDURE
1. Slide the recliner motor on to the shaft




2. Install the recliner motor nuts (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 10 N.m (88 lb in).
3. Install the electrical connector.
4. Install the recliner position sensor.
5. Install the seat into the vehicle.