Knock Sensor Replacement - Bank 1

KNOCK SENSOR REPLACEMENT - BANK 1

REMOVAL PROCEDURE




- Turn the ignition OFF.
- Raise and support the vehicle. Refer to Vehicle Lifting.
- Reposition the wiring harness heat shield to obtain access.
- Remove the knock sensor (KS) electrical connector.




- Remove the KS bolt.
- Remove the KS.

INSTALLATION PROCEDURE




- Install the KS.
- Install the KS bolt.

NOTE: Refer to Fastener Notice.

Tighten the KS bolt to 23 N.m (17 lb ft).




- Install the KS electrical connector.
- Install the wiring harness heat shield to the original position.
- Lower the vehicle.