Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

CAMSHAFT POSITION SENSOR REPLACEMENT - BANK 1 (RIGHT SIDE) EXHAUST

REMOVAL PROCEDURE
- Turn the ignition OFF.
- Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.

IMPORTANT: Do not remove the engine control module (ECM) from the ECM bracket.

Do not remove the ECM redundant ground wire from the ECM.




- Remove the camshaft position (CMP) sensor electrical connector.




- Remove the CMP sensor bolt.
- Remove the CMP sensor.

INSTALLATION PROCEDURE




- Install the CMP sensor.
- Install the CMP sensor bolt.

NOTE: Refer to Fastener Notice.

Tighten the CMP sensor bolt to 10 N.m (89 lb in).




- Install the CMP sensor electrical connector.
- Install the ECM bracket with the ECM.