Transmission Vent Tube Replacement

Transmission Vent Tube Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the propeller shaft.
3. Support the transmission with a suitable jack.
4. Remove the transmission support.
5. Lower the jack to gain access to the top of the transmission.
6. Remove the bolt (1) securing the vent hose to the transmission.
7. Remove the vent hose (2) from the vent pipe.

Installation Procedure





1. Install the vent hose (2) to the vent pipe.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the shift guide plate bolt securing the vent hose (1) to the transmission.

Tighten the shift guide plate bolt to 22 Nm (16 ft. lbs.).

3. Raise the jack.
4. Install the transmission support.
5. Remove the jack.
6. Install the propeller shaft.
7. Lower the vehicle.