Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE
1. Remove the center I/P air vents.
2. Remove the HVAC programer/ashtray assembly.




3. Remove the 4 10 mm screws securing the radio to the I/P retainer.
4. Pull out the radio assembly.
5. Disconnect the electrical connectors.
6. Remove the radio from the vehicle.

INSTALLATION PROCEDURE




1. Connect the electrical connectors.

NOTE: Refer to Fastener Notice.

2. Install the radio assembly to the I/P retainer.

Tighten the screws to 9 N.m (80 lb in).

3. Install the HVAC programer/ashtray assembly.
4. Install the center I/P air vents.
5. Reprogram the radio. Refer to Control Module References for programming and setup information. Programming and Relearning